Metropolis: King of Hackers!

Chapter 431 : Top mecha!

And alloy-ceramic composite armor plates with key parts exceeding 20mm. The price of the full armor plate has reached a high price of more than 500,000 yuan.

Under the armor plate, there is a rubber buffer layer with an average thickness of 4mm, and various hydraulic piping systems hidden in the buffer layer. Especially the hydraulic pipes, because they will bear huge pressure, are made of special materials, the price of each set of metal exoskeleton pipes, plus the cost of the rubber buffer layer, exceeds 100,000 yuan.

There are also electronic system equipment inside the metal exoskeleton, including micro scanning radar, infrared detector, small computer, GPS locator, satellite communication connection module, camera monitoring device, etc.The price of all electronic equipment also exceeds 500,000 degree.

There are some fragmentary parts, such as eyepiece imaging technology, special eyepiece glass. Equivalent to the HUD technology of a fighter jet, this technology helps the pilot of the metal exoskeleton to know the situation of the metal exoskeleton at any time. Such as armor damage, fuel remaining, current position information, radar scan status, thermal imaging view, and

Instant battle information and more. The cost of these fragmentary parts is about 100,000 yuan.

Calculated as a whole, the cost of a set of metal exoskeleton is temporarily not included in the labor cost, not included in the R&D cost, not included in the sales profit of the military’s internal manufacturing, and also not included in the value of the operating system that Chu Hao has not yet developed. The cost price of the exoskeleton has reached 5.8 million-above.

If you count the cost of all additional gains, I am afraid that the cost will exceed the 8 million mark!

With such a terrifying cost, it is still unknown whether it can form effective combat effectiveness. After all, the operating system written by Chu Hao has not yet been completed.

Once the operating system is completed, load into the internal computer of the metal exoskeleton to test the combat effectiveness of the metal exoskeleton. Only then can I know the exact geometry of the combat power of the metal exoskeleton!

At 12:20 midnight on January 9th, Lin’an Underground Base, the second floor.

The second floor of the Lin’an Underground Base is currently completely occupied by the metal exoskeleton project team. Dong Guoguo leads everyone and gathers in the test area.

The personnel of each research group, with corresponding metal exoskeleton parts, assemble the whole metal exoskeleton together on the operating table in the test area.

With the help of machinery, after about half an hour, the metal exoskeleton was assembled!

The metal exoskeleton is in matt silver gray as a whole, and there is no reflection under the light, which effectively prevents the reflection from being found.

The specific parameters are as follows:

……For flowers………

Height: 2200mm

Body weight: 524kg

The body is full of fuel: 550.25kg, the fuel tank is fully loaded

Weapon mode: 710.25kg, equipped with 160kg alloy epee

Mixed mode: 1060.25kg, equipped with 160kg alloy epee, equipped with 350kg alloy shield

Power source: all-ceramic micro-turbine engine

…………0

Power: 25 horsepower + 25 horsepower

Fuel tank capacity: 35L

Armor type: special alloy armor + special ceramic armor

Armor thickness: 10mm–22mm

Inner cabin height: 1810mm

Driving and occupant height limit: 1780mm–1800mm

Weight limit for driving occupants: 70kg–75kg

Theoretical maximum combat speed: 30m/s

Theoretical maximum combat time: 300min

Theoretical maximum standby time: 900min

The inner cabin of the metal exoskeleton is the space for the driver. Because the driver needs to be completely wrapped in it, the physical fitness requirements of the driver are very strict.

Too fat to squeeze, too high to hold, and vice versa. earth,