binary dead train

Chapter 58 Experiment ([-])

[You successfully disassembled and researched this technology, and gained 5 technical points]

[You successfully disassembled and researched this technology, and gained 4 technical points]

[You successfully disassembled and researched this technology, and obtained...]

Reminders of new technologies are constantly jumping in the retina, and the phantom limbs are quickly dismantling the implants of the beekeeper.A steady stream of technical knowledge poured into Turing's mind.

"honeycomb?"

Turing's eyes were blank, and he felt the knowledge disassembled by phantom limbs pouring into his mind.

"It turns out that this thing is not a honeycomb at all, it's just a superficial thing."

When the information finally stopped pouring in, Turing blinked and looked at the messy desktop.

The phantom limb is controlling itself in Turing's unconscious state, putting the beekeeper's mechanical chest back together.

Then, Turing pulled the robot controlled by Huguang, but stopped after the phantom limb disassembled the shell of the chest cavity.

"Is there not enough knowledge to understand..."

Turing observed a large number of circuit boards inside the robot's chest, as well as power furnaces and other things, so he didn't get too entangled and gave up dismantling for the time being.

"It may also be because the internal structure is too sophisticated, making it difficult for phantom limbs to touch."

Turing thought for a while, put the robot aside, manipulated the phantom limb to pose it a dancer's pose, and gave up temporarily.

Then Turing called up the technology tree to check the main knowledge obtained from the beekeeper:
【Portable Tektronix Factory】

【Tektronix Signal Transceiver】

【Tektronix overload device】

【Simple Bee Robot】

【Tektronix Speed ​​Wheel Blade】

Tech value: 20.
Obtaining this knowledge, plus what he had before, brought Turing a total of 20 technical points.

The Bee Robot and the Tek Speedwheel Blade are obtained by dismantling the Beekeeper.

This speed wheel blade is not a "high-frequency blade" with high technological content, but a special spinning blade excited by decarburization particles. When combined with a bee-shaped robot, the robot can become a blade to provide force support.

Combined with the information Turing obtained from Huguang Corporation, the "decarbonization particle" he called before is called the "Tek particle" among the technology hunters.

Including the name of tech hunters for cyborgs, the full name is "Tech cyborgs".

These different names, in Turing's guess, may be related to different systems.

Carbon changers call this energy "decarbonization particles".

To transform people, this kind of energy is called "Tek particle".

And Geller Sting's world is named "Demon God Factor".

The three must be different in certain characteristics, but Turing thinks he has not discovered it yet.

Combining these knowledge and information, then the world of the dead train must have some connection with his own real world.

Digesting and combining the information in his mind, Turing looked at the new technology tree icon on his retina, thinking about how to use it.

The beekeeper's "Tek hive", after Turing's dismantling and analysis, is actually a portable small factory, which was transformed and implanted in the chest cavity by the beekeeper.

This small factory can, to a certain extent and scale, directly manufacture and power the bee-shaped robot in the chest cavity.That is, the "Tek killer bee" in the beekeeper's mouth.

The self-detonation principle of the bee-shaped robot is actually a simple energy overload device, which can detonate the Tektronix particle energy of the bee-shaped robot.

Beekeepers use Tektronix transceivers to control these bee robots.

As for the robot's sound amplifier and the spread of vision, it is not within the scope of Tektronix technology, it is just an ordinary machine, but it also brings technological advancement options for phantom limbs.

Another detail is the camouflage technology that transforms those bee-shaped robots into the appearance of ordinary bees. Turing failed to disassemble it on the beekeeper, which is a doubtful point.He could only attribute it to the high level of sophistication of the technology, which the phantom limb and himself could not understand.

"Then the question is, how do I use it?"

Turing looked at the technology tree interface in the retina, thoughtful.

after an hour.

Turing's upper body was naked with his back facing the mirror in the basement. The main body of the phantom limb behind had covered the spine and half of the back, and formed an outwardly expanding mechanical sheet on the ribs.

On the main body with the most protruding spine, there is an additional orange LED light, which flickers on and off with Turing's breathing.

This is the change of the phantom limb after Turing climbed the [Portable Tektronix Factory] and [Tektronix Signal Transceiver] for the phantom limb.

The breathing light on his back is the signal transceiver.The phantom body that covers too much is the result of climbing the factory.

Turing's heart moved, and some changes began to occur inside the phantom limb.

Manipulating a phantom limb to open, a mechanical bug was ejected from the center of the claw, flying in front of Turing's eyes.

After climbing up the Tektronix factory, the phantom limbs have not changed much, but the inside of each phantom limb seems to have become a channel factory, which can multiply small machines in batches. However, Turing only knows the structure of the bee robot now, so he only knows Can make little bees.

This bee is roughly the size of a thumb, with a very small light spot on the tail needle on its butt.

After a simple experiment, this mechanical bug is similar to a beekeeper, and can share the captured images and sounds with its own perception through the Tektronix signal transceiver.

And Turing can also sink into his mind and enter the perspective of a mechanical bee for independent control.

In order to test how far the control range of this bee is, Turing tried to control a bee alone, and then manipulated it to fly out of the basement, leave his house, and came to the street outside.

It was dusk at this moment, and Turing controlled the bee to cross the street, fly over the fence, pass by a group of motorcycle men in leather jackets, and then fly into a building, and saw the office workers typing on the keyboard inside.

In this way, Turing controlled the bees to shuttle continuously, until at a certain moment, a feeling of being out of control came, and he stopped his thoughts and ordered the bees to return, and then opened his eyes.

A few minutes later, the mechanical bug returned to Turing's palm.

Recalling the cityscape and buildings he had just seen, Turing took out his phone and turned on the navigation.

"It should be in this area just now... the communication range is 2000 meters?"

2000 meters is not bad, but I don't know what will happen if the bees are controlled to fly out of the range.

Simply ending the range experiment, Turing let the phantom spit out another bee, and controlled the bee to get into the ear of a monster.

He wanted to try, whether through these bees, he could achieve indirect remote control of the monster equipment, and give orders to these guys.

　Change first, change later, and update a chapter later

Recently, my mentality has exploded, woo woo

　
(End of this chapter)